INDUCTIVE TEST
The Creasoft Inductive Test verifies the correct placement of the cables that share a common extreme.
The most common application of the inductive test is in the fuse box at the battery output.
- System to detect the correct position of wires in metal plate splices.
- Managed by a 8 sensors in an electronic card controller, connected to computer using a Ethernet connection.
- Easy to calibrate.
- Unlimited number of sensors in a system.
- Integration with Creasoft products.
The charts are scalable which gives the system the ability to check unlimited cables using inductive sensors. The system is easy to install and low maintenance.
The software is fully integrated with the HETOS system, it is applicable to both a screwing stations and a wire harness test table.
It comes with a calibration application that simplifies the only maintenance process.